When installing the magnetic suspension blower, the safety of the equipment can be guaranteed from the following aspects:

First, the preparation before installation

Site evaluation

Conduct a comprehensive evaluation of the installation site to ensure that the site has sufficient bearing capacity to support the weight of the equipment and avoid the instability of the equipment due to problems such as ground collapse.

Check the surrounding environment of the site, and stay away from inflammable, explosive and corrosive substances and adverse environmental factors such as high temperature and high humidity, so as to prevent damage to equipment or safety accidents.

equipment inspection

Before installation, carefully check whether all parts of the magnetic levitation blower are intact, especially the key parts such as magnetic levitation bearings, motors and impellers.

Check whether the specifications, models and parameters of the equipment are consistent with the design requirements and ensure that the equipment meets the installation conditions.

Second, the safety measures in the installation process

Professional installation team

Hire an experienced and qualified installation team to install the equipment. The installer should be familiar with the installation process and safety specifications of the magnetic levitation blower and operate in strict accordance with the operating procedures.

The installation team should be equipped with necessary safety protection equipment, such as safety helmet, safety shoes, safety belt, etc.

Correct installation method

Install in strict accordance with the installation manual provided by the equipment manufacturer to ensure that each step is correct.

During installation, pay attention to the center of gravity and balance of the equipment to avoid the equipment from tilting or overturning. Use appropriate hoisting equipment and tools to ensure the safety and stability of the hoisting process.

When connecting the electrical wiring, it must be operated by a professional electrician to ensure that the wiring is correct and firm and meets the electrical safety standards.

safety device

Check whether the self-contained safety protection devices of the equipment are complete and effective, such as overcurrent protection, overheating protection and vibration protection. Ensure that these devices can function normally during the operation of the equipment.

According to the actual needs, we can consider installing additional safety protection facilities around the equipment, such as fences and shields, to prevent people from touching the equipment by mistake or being injured by the running parts of the equipment.

Third, debugging and testing after installation

Pre-commissioning inspection

Before debugging the equipment, conduct a comprehensive inspection on the installation of the equipment again, and confirm that all components are firmly installed, the electrical connection is correct, and the safety protection devices are in good condition.

Check whether there are obstacles around the equipment to ensure that the equipment has enough running space during debugging.

Safety precautions in debugging process

When debugging, it shall be operated by professional technicians in strict accordance with debugging procedures. Gradually increase the load and speed of the equipment, observe the running state of the equipment, and find and deal with abnormal situations in time.

During debugging, pay close attention to various parameters of the equipment, such as current, voltage, temperature, vibration, etc., to ensure that these parameters are within the normal range. If abnormal parameters are found, stop debugging immediately, find out the reason and deal with it.

During commissioning, irrelevant personnel are strictly prohibited from approaching the equipment to prevent accidents.

Safety inspection and acceptance

After the installation and debugging is completed, conduct comprehensive safety inspection, including electrical safety inspection, mechanical safety inspection and protective device inspection. Ensure that the equipment meets the relevant safety standards and specifications.

Invite professional testing institutions or equipment manufacturers to conduct acceptance and issue acceptance reports. Only after the acceptance, can it be officially put into use.